All

All
Product Management
News and Information
Frequently Asked Questions

Product Series

Contact Information

Company Address No. 3716 Qingdao Road, Huaiyin District, Jinan City, Shandong Province, Unit 1801, China Construction Jinxiu Plaza.

Production base Juye Chemical Industry Park, Heze City, Shandong Province.

Nanjing Branch Company Room B2304, Nanjing University of Technology (Dingjiaqiao Campus), No. 5 Xinmofanma Road, Gulou District, Nanjing City, Jiangsu Province.

Phone ： +86-531-88986356

Phone ：+86-15562623709
Email ： sdprio@sdprio.com

DTR0-515 Cleaning Agent (Alkaline)

Category:

Membrane treatment chemicals

Request a quote now

Related Downloads

Send email

Keywords:

Membrane treatment chemicals

Detailed introduction

Product Performance

DTRO The cleaning agent is an alkaline, composite liquid formulation suitable for... DTRO Membrane, CA And TFC Chemical cleaning of the membrane element series. It causes no damage to the membranes and exhibits strong permeation and solubilization capabilities against sludge, organic matter, oils, microorganisms, viscous substances, and non-acid-soluble materials, while also preventing secondary sedimentation contamination during the cleaning process.

Technical indicators

Project	Indicator
Appearance	Colorless, transparent liquid
pH (1% aqueous solution)	11.0–13.0
Specific gravity (20℃ g/cm³)	1.10 ± 0.05
Minimum storage temperature (℃)	<-15

Method 1: Note: The usage of acidic cleaners is the same as that of alkaline cleaners.

(1) Check the connection of the cleaning circuit: The cleaning tank, pipelines, and safety filter have been properly connected. Clean them thoroughly with demineralized water, performing at least two cleaning cycles. If necessary, install a new filter cartridge into the safety filter.

(2) Inject half the volume into the cleaning tank, then slowly add the pre-calculated cleaning agent into the cleaning tank and mix thoroughly. Ideally, the temperature of the cleaning solution should be controlled at... 30 About degrees.

(3) According to the cleaning circuit, start the cleaning pump and begin the cleaning process. The volume of the cleaning agent is approximately that of the cleaning fluid. 5%-15% The cleaning flow rate and velocity should follow the recommended values provided by the membrane manufacturer or system supplier. The cleaning duration depends on the degree of fouling; generally, 12-24 An hour.

Please consult Prio's technical engineers to determine the dosing points and dosing amounts based on your specific system conditions. In certain systems, specific dosing points and injection equipment are essential.

Cleaning Instructions

(1) Check the connection of the cleaning circuit: The cleaning tank, pipelines, and security filter have been properly connected. Clean them thoroughly with demineralized water, performing at least two complete cleaning cycles. If necessary, install a new filter cartridge into the security filter. During cleaning, circulate the prepared cleaning solution at low pressure and high flow rate on the concentrate side of the membrane; at this stage, the membrane elements remain installed inside the pressure vessel.

(2) Fill the cleaning tank to half its volume with reverse-osmosis permeate or demineralized water. Slowly add the pre-calculated amount of cleaning agent into the cleaning tank, and mix thoroughly. Ideally, maintain the cleaning solution temperature within... 30 Around ℃.

(3) According to the cleaning circuit, start the cleaning pump and begin the cleaning process. Initially, the effluent will flow out. R0 The membrane cleaning solution should be drained from the system, with a volume approximately equal to that of the cleaning tank. 10%-20% The cleaning flow rate and velocity should follow the recommended values provided by the membrane manufacturer or system supplier. The cleaning duration depends on the degree of fouling; generally, 8-12 An hour.

Related Downloads

Application scenarios